![]() ![]() This tool snaps to walls or can be placed freely in the 3D drawing view. Use the Image on wall tool from the Wall drawing component tab and double-click it in the 3D view to bring up the PDF import dialog where you can follow the steps described above. A similar tool can be used for walls, or just to place images vertically in 3D.You can easily change the image within the frame by dragging a file from your computer and dropping it onto the inserted component.CET supports image transparency as seen in the. Supported file formats for images are: bmp, gif, tif, jpeg, pdf and png.Activate 2D: When checked, you can snap certain tools (lines, walls, dimensions, etc.) to some lines within the image.Scale: If the scale of the imported image/drawing is known, you can enter it in this field.Measure and scale: If the scale is unknown, you can use the Measure and scale tool to determine and set the scale.Brightness: Increases or decreases the brightness of the imported image in the 2D drawing view.Front means that it will always be on top, while Back will set the image behind all other 2D objects. 2D Position: Set the image visibility in the 2D drawing view.Show in 3D view: Shows the image as a flat surface in the 3D drawing view.Keep aspect: Locks the aspect ratio of the image preventing it from getting distorted when stretched.Lock position: Locks the image’s position to prevent it from being moved accidentally.Select the image/page to bring up the green Quick Properties box where you have the following options: If the image must be at a specific scale, you can use the Measure and scale tool. If you wish to change to another image or PDF file, double-click on the image in the drawing view to re-open the Load dialog, or drag-and-drop a new file inside of the frame in the 2D drawing view.Ĭlick and drag the yellow snap points to adjust the size. You can click Load PDF to select a different file, or if you're done, close the PDF import dialog window. Click to select the content that you wish to import, and then click the Insert button, or double-click on the page or image. ![]() In the PDF import window, you can choose to place an entire page of the PDF, or click Images at the top to select an individual image from a page.If you are loading a PDF, the PDF import window opens: Alternately, you can drag a file from your computer and drop it within the frame. Browse for the desired image or PDF file, select the file and click Open.Release the component by moving the cursor outside of the drawing area or pressing Esc on your keyboard.Left-click once to set a starting point, then move the cursor until the frame is the desired size (without holding down the mouse button) and click once to set the ending point.Ĭlick-and-drag the frame to make it the desired size. An image component is now attached to the cursor. Under Image and Text, select the Load Image component.Drag-and-drop an image file from your internet browser into the drawing area in CET.Drag-and-drop an image file from your File Explorer in the drawing area in CET.There are a few methods to insert images: Bmp, dib, gif, jpg, jpeg, dng, png, tga, tif, tiff, pdf ![]()
0 Comments
Leave a Reply. |